How Does the Phantom Grip Work?

 Phantom Grip's precision cut disc plates function as a disc-type limited slip in cornering and braking. Disc plates exert equal load against spider gears using spring pressure to control the amount of slippage at the wheels. Helping to accelerate quicker, while sustaining higher speeds through corners.

Phantom Grip offers 100% locking in hard acceleration. When torque is applied through acceleration the disc plates pivot, locking the spider gears, causing both wheels to exert equal power to the road, providing less torque steer than an ordinary differential. Although seemingly simple, the 'Phantom Grip design' offers as much maximum traction as other limited slips.

 

Does the Phantom Grip LSD Conversion Kit Come With A Warranty?

The Phantom Grip is extremely strong and durable and comes with a Lifetime Warranty against manufacturer defects which is a product replacement.

 

"Disclaimer of Warranty"---WARNING: Installation of any Phantom Grip component or kit should be performed by persons experienced in the installation and proper operation of transmission and drivetrain products. Purchasers expressly affirm they are relying upon their own skill or judgment to select and purchase Phantom Grip limited Slip conversion kits. Warranties are void against incorrect installation, or modifications done to Phantom Grip units.

 

Tech Tips-------phantom grip diff

 

Tip #1--Installation on Basic Diffs
Basic open differential installation instructions for qualified installers with transmission knowledge only. See them here.

 

Tip #2--Resurfacing of  Diff Gears for Clearance Tolerances or Gear Casting
* The more flat the spider gear surface is, the better your   Phantom Grip Limited Slip Kit will work.

* Resurfacing will be needed if a raised casting lip is on the gear face that will mate with the Phantom Grip unit. It will need to be removed and can be done with patience on a bench grinder/table saw,mill or a lathe if you have access to one. (If you don't remove that casting lip, it will grind a ring into the Phantom Grip unit and there will not be enough mating surface there to get any type of performance.

* Remember-the more mating surface with the Phantom Grip, the better.

* Clearances do not have to be exact, only be concerned if clearance is are more than
0.030.

Clearances between 0.005-0.010 is the recommended amount.

A nice precise fitment with a smooth flat mating surface is necessary and even resurfacing the gear face to freshen up the surface is suggested.

Tip #3-Spring Load

* Check springs for coil bind when using tuning shims from your upgrade spring kits. You can take just a bit off the green spring where it will sit in the spring seat, if you need too.

 

Tip #4
* Always check part # if your unit does not fit by more than 0.030. Contact us direct, if you feel it is not correct.

  

Supplemental Additional Installation Instructions

 

Classic Mini Phantom Grip Limited Slip Install Guide

Merkur XR4TI Phantom Grip Limited Slip Install Guide

VW 02A Phantom Grip Limited Slip Install Guide

VW 02O Phantom Grip Limited Slip Install Guide

 

Additional Tech Tips & FYI
1. Saturn Owners need to remove thrust washers.

 


 

Left Turn Without Phantom Grip

  

  


Left Turn With Phantom Grip

  

  

Straight without Phantom Grip

  

  

Straight with Phantom Grip